Barnfind 6.3 – Bonnet release

One of the first jobs I have to do on the barn find 300SEL 6.3 is swap the fuel pump.  However, I had a problem.  When I first got the car, I tried to open the bonnet and the bonnet release cable broke off the latch and seemed to be jammed.  Since the battery is totally dead, I guess I could change the pump without disconnecting it.  However, it wouldn’t do me much good once the job was done, as I wouldn’t be able to test it.

Before I even attempted any other maintenance, I really needed to get the bonnet open.

I first tried using pliers on the end of the cable.  This was how I always opened the bonnet of my old 250SE coupe i owned in Detroit.  I was able to get the cable to move, but not enough to pop open the bonnet.

250SE Bonnet release

It was useful to have my 250SE on hand.  While they are different models, the bonnet release is the pretty similar.   I was able to see how the release mechanism worked without the grille in the way.   The photo above shows the mechanism of the 250SE.

From what I could see, if I could get the right angle through the slats in the grille mesh, I should be able to push on the lever that the cable actuates.  This wouldn’t have ben possible on the 111 as it has a very fine grille mesh.

I first tried a screwdriver, but I didn’t have one long and thick enough.

6.3 bonnet release

Next I tried three 1/4″ socket extensions.  This was close, but due to the three parts connected, they sagged.   I went to Bunnings warehouse (a hardware store here in Australia) and purchased a very long 6mm threaded rod, a couple of joiners, a few wingnuts and a couple of other attachments.   I thought I could use the threaded rod with the joiner on the end push against the rod.  The joiner would act sort of like a ‘cup’ against the rod, so it wouldn’t slip off.   If that didn’t work, the wingnuts ear may have allowed me to pull on the cable from the other side.

Barnfind 6.3 – Bonnet release

In the end the rod with the joiner worked.  At first I wasn’t able to get the rod to move, but if I pushed down on the bonnet first, and then pushed the rod, it moved and i was able to get it up.  It took me about an hour of fiddling around.

6.3 bonnet release

With the bonnet open, I put a rag over the mechanism so i don’t accidently close it for now.   At some future point I’ll probably replace the cable and lubricate the mechanism.

6.3 bonnet release

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *