Barnfind 6.3 – Fuel Pump Replacement
The 6.3 had been parked up about 18 months earlier, with an apparent bad fuel pump. The previous owner was going to change it, but heath issues got in the way.
One of my first tasks would be to replace the pump. The car had been set up to use a K-jetronic pump some 15-20 years ago and had been using that pump ever since. This is a bit unusual. From my research most 6.3s are set up to use either the standard pump or a D-jet pump. The K-jet pump is higher pressure, which isn’t needed for MFI.
Despite all that, the car had run very well for the last 15-20 years. Since it came with a replacement K-jet pump so I was going to just use that.
From looking at the service history, it looked like the strainer in the tank has been changed in October of 2012 when the tank was removed, cleaned and sealed. However, since the hose between the tank and the fuel pump looked quite old and perished, I figured it was worth changing the strainer. The strainer is part number A111 470 06 86.
I first drained the fuel using the old perished hose. It I’m glad I was going to replace it, as the hose started to disintegrate once I put any pressure on it. The old fuel was clean, but smelt a bit old.
Once the tank was dry, I removed the old strainer. That required a 21mm hex. The old strainer was actually pretty good, and probably could have been cleaned and re-used. However, I had a new one and decided to install it.
I then removed the old pump. It looked a bit old, but there was nothing obviously wrong with it and there was no debris inside. Instead of a screw fitting on the outlet of the pump, as used by a K-jetronic system. The new pump had the normal screw fitting, so I assumed I could transfer it over. However, the new pump was a bit different to the old one. The fittings were of a different diameter and therefore not compatible.
I probably could have found fittings that did work. However, my decision to use another K-Jet pump was based on that being a simple swap out. Since it now wasn’t, it felt better to use a more usual pump for this car. I had a rebuilt short pump, but I felt a D-Jet pump would be easier to adapt and so I used one of those instead.
The D-jet pump is the same basic shape as the K-jet, just a bit smaller. That meant it mounted up pretty quickly. The old pump had quite a nifty valve to turn off the fuel, however, that was too large to easily adapt to the new pump, so I didn’t use it.
Getting the pump installed was pretty simple, however one odd thing was that it used nylon nuts to hold the electrical connections on. That was needed as the touched the metal outlet and metal ones could have caused a short. They were quite fiddly to get on.
The ring terminal on the ground wire was damaged, so I replaced it.
Obviously doing all this, there was no battery in the car and I had the correct fire extinguisher nearby. With the new pump in place I got out the new battery I had purchased for the car. The old one was totally dead. The battery tray is currently out, as the previous owner had just changed the spark plugs before parking up the car. There was also a ground strap that was not connected to anything. It seemed an odd place, but there was a single bolt in the exhaust manifold where a heat shield would normally go. It would have been in the way to change the plugs, I tried connecting it to that.
However, I don’t think it is right, as I heard a click when trying to start the car, but no engagement of the starter. I tried messing with the neutral safety switch, but just managed to have the plug disintegrate in my hand. So my next task will be to try and get the neutral safety switch plugged back in, and also trace that ground strap more.

























